4” X 48” Phillips / Technidrill BTA Ejector Type Deep Hole Drilling Machine |
|
Stock Code: |
HSD1170 |
Price: | $RFQ |
Subcategory: | Deep Hole Drills |
Year of Manufacture: |
1981 |
Manufacturer: |
Phillips |
Model: |
BTA |
Condition: | Used |
Drilling Diameter, Maximum
4”
Drilling Depth, Maximum
48”
Feed Rate
.5 to 12 IPM
Swing Over Ways
20”
Swing Over Work Surface
32”
Spindle Speeds
Variable (Parker DC VS Drive)
Spindle Horsepower
40 HP
High Pressure Coolant Pump
15 HP
Electrics
3/60/480V
Approx. Drill Dimensions
188” x 48” x 72” Height
Approx. Coolant System Dimensions
128” x 64” x 96” Height
EQUIPPED WITH:Operators Control Station with Spindle Pressure / Drill Monitor Load Meter. Spindle RPM Display. Spindle Variable Speed Controller. Feed IPM Thumb Wheel Selector. Manual and Automatic Operation Controls. Manual Operation Controls for Spindle Run. Coolant. Rapid Advance. Forward Feed, Retract, E-Stop, and Emergency Retract. Updated with Parker DC Spindle Speed Drive.
High-Pressure Coolant Filtration System with 7.5 HP Filter Pump that Removes Coolant from the bottom of the Settling Tank and Pumps it Through Filters into the Clean Coolant Top Tank. Micron Polishing Filtration with (2) Cartridge Type Filters. 15 HP Grundfos High-Pressure Coolant Pump. Chip Conveyor. Air-Oil Mist Lubrication to the Spindle. Automatic Way Lubrication System. Transformer.
32
x 72
T-Slotted Work Surface. Tailstock with Spring Loaded Cup Type Support. (3) Pressure Heads. Large Assortment of Spring Collets for Pressure Heads. (2) Drill Bush Heads with Large Assortment of Sleeves, Bushings, and Lock Nuts. Large Assortment of BTA Tubes (Some Extend for up to 96
Drilling). Large Assortment of BTA Drill Heads.
This machine is listed for sale by Adams Machinery Company
located in Lake Bluff, Illinois